DL-GR7300. Grinding machine for the needles of nozzles with speed indicators

Grinding machine for the needles of nozzles with speed indicators

The rotation speed of the spindle and the machined body is displayed .

Rotation speed of the spindle and the machined body is adjusted by rotary knobs located on the control panel.

The brightness adjust using the rotary knob located at the top of the control panel.

On the control panel there is a switch for the general power supply of the machine and three power switches for each electric motor of the corresponding drive and the lower illumination.

On the backside of the machine, there is a connector for the power cable 220V, two 220V sockets and a 12V socket for connecting a monitor.

On the front side of the machine housing is a 12 volt connector for connecting the power cable of the motor to drive the bodies of rotation.

Grinding machine
Drive pulley with an inner diameter of 3 mm
Drive pulley with an inner diameter of 4 mm
Drive pulley with an inner diameter of 7 mm
Grinding wheel repair pen
Power supply cable 220 Volt
Manual
НКУ DL-GR7300

Additional equipment to DL-GR7500

DL-UNI20200 Abrasive stone (wheel), grid 400
DL-UNI20201 Abrasive stone (wheel), grid 200
DL-UNI20202 Abrasive stone (wheel), grid 100
DL-GR1050 Stone(wheel) holder
DL-GR1060 Shaft for balancing stone (wheel)
DL-GR1070 Balancing device
DL-GR1080 Angle Measuring Kit

The maximum spindle rotation speed is 7300 rpm

The maximum speed of the sharpened body is 1200 rpm

Main motor power supply voltage is 36 V.

Power supply voltage of the electric motor drive – 12 V.

Grinding wheel – fine-grained electrocorundum